Faced with one of the driest periods in state history, Governor Gavin Newsom asked California residents in July to voluntarily reduce water use by 15%. So far, we’ve missed the mark in water conservation, reducing consumption by just 5% from a year ago.
Saving 15% can seem daunting, but every little bit of conservation adds up and makes a difference.
How can we do better? Saving 15% can seem daunting, but every little bit of conservation adds up and makes a difference. Here are some water saving tips I’ve implemented in my own household that are simple and did not require a lot of effort. I’m eager to get my next water bill to see how much I’ve saved.
Check for leaks
There could be a leak in your home, and you might not even know it. To check, don’t use any water for two hours, but make a note of what’s on your water meter before and afterward. If the meter numbers have gone up, you have a leak and it’s time to hire a plumber to investigate.
Save in the shower
A whopping 75% of water usage happens in our bathrooms. And a lot of that is from the shower. According to the American Water Works Association, a typical shower lasts eight minutes. With a standard showerhead that uses 2.5 gallons of water per minute, each shower can add up to 20 gallons of water. So if you reduce your daily shower time to five minutes, you will save 225 gallons every month. If everyone in the family does this, imagine how much water you’ll save.
Stop flushing so much
I don’t mean to be graphic, but you don’t really need to flush your toilet every time you use it. Some older toilets use up to seven gallons of water per flush. Even the newer ones, which are required to consume no more than 1.6 gallons per flush, make up a substantial part of your water usage. By flushing just one time less each day, we can reduce our monthly water usage by a minimum of 584 gallons a year.
Make your older toilets flush less water
A simple way reduce water use is to minimize the amount of water that goes into your toilet tank. To do so, fill a plastic half-gallon bottle (such as an orange juice or bleach bottle) half-way with rocks to weigh it down, then fill it with water and tightly close its lid. Place the container inside your toilet tank, and you will save a half gallon each time you flush. Note: sometimes people put a brick in the tank for this same purpose, but bricks can erode and add sediments to your toilet.
Turn off the tap while brushing
This sounds really obvious, but leaving water running while brushing is a bad habit many of us can’t seem to break. However, when you know that every minute 3 to 5 gallons of water comes out of the average faucet, you’ll realize this is just another simple opportunity for saving water.
Use the dishwasher more
According to the Natural Resources Defense Council, using an automatic dishwasher is more water efficient than hand washing. New Energy Star® dishwashers use three to five gallons of water per wash, compared to up to 27 gallons used by traditional hand washing, counting for those who let the water run the entire time they’re washing. Even older dishwashers that use up to 15 gallons per wash beat traditional hand washing. Just be sure to run your dishwasher only when it is fully loaded. And scrape your dishes first, instead of rinsing them before putting them in the machine.
Only wash full loads of clothes
The Alliance for Water Efficiency estimates the average American family washes almost 400 loads of laundry each year. That’s a lot of laundry. You can make the most of each load by making sure the machine is filled, even if the washer has adjustable load settings. And avoid the permanent press cycle, which adds up to 5 gallons for the extra rinse. If you’re planning to replace an older washing machine, which typically use 40 to 45 gallons per wash, consider either a front- or top-loading high efficiency model, which generally uses only 14 to 25 gallons.
Keep a bucket handy for reuse
Don’t let water go down the drain when it can be used for other purposes, like watering plants or cleaning. If you have to let the water in your sink or tub run for a few seconds to heat up, collect the cold water in a bucket to use later. You’ll be amazed at how much water you collect – all of which would otherwise just disappear down your drain.
Jonathan Fong is the author of “Flowers That Wow” and “Parties That Wow,” and host of “Style With a Smile” on YouTube. You can see more of his do-it-yourself projects at jonathanfongstyle.com.
